The Two-Minute Conversation That Prevents Non-Adapts
Updated: 2 hours ago
By Durhl Davis, ABO-certified optician, Candor Wholesale Optical Laboratory
Most non-adapts don't start at pickup. They start at the order desk, when nobody told the patient what to expect.
Early in my career, I picked up a habit that saved me more remakes and more frustrated patients than anything else I've done: before I made the lenses, I took two minutes to look at what was changing and talked to the patient about it. Then, at pickup, I controlled the dispensing instead of just handing over the glasses.
Before the order: look for what's changing
Put the old Rx and the new Rx side by side, and look at the old glasses next to the new frame. Ask:
Did the prescription change much? A big jump in sphere, cylinder or axis will feel different, even if it's correct.
Is this a first pair of progressives, or a switch from lined bifocals?
Is the frame a very different size or shape? A much smaller frame shrinks the reading area of a progressive.
Is the lens design or material changing?
Anything on that list deserves a short conversation. Tell the patient what will feel different before they ever put the glasses on.
For a first-time progressive wearer, that sounds something like: "To read, you'll point your nose at what you want to see. Off to the sides, things will be blurry. That's normal for every progressive lens, not something wrong with yours."
The industry calls that side area "soft focus." I've always thought that was a fluff term. It's distortion, and patients handle it better when you're straight with them about it.

At pickup: control the dispensing
Don't just hand over the glasses and ask how they look. Walk the patient through the lens:
Hold a reading card at eye level, straight ahead, at distance.
Ask the patient to keep their head still and follow the card with their eyes.
Slowly bring the card down. Their eyes follow it through the corridor, into intermediate, then near.
Move the card to the left or right. Their eyes follow it into the distorted area, and they see it blur.
Now have them point their nose at the card. It's clear again.
In under a minute, the patient has felt every part of the lens and learned how to use it. Nothing surprises them later, because they've already seen it with you standing there.
Adaptation is faster when the patient knows what's going to happen before the glasses are on their face.
When a patient still comes back
Even with good preparation, some will. Before sending glasses back, work through this list:
Listen first. "Blurry at the computer" and "the floor tilts" point to different problems.
Check the frame fit: pantoscopic tilt, vertex distance, level and wrap. Adjustment fixes more complaints than remakes do.
Verify the Rx in the lensometer against the prescription and tolerance.
Check the measurements: monocular PDs, optical center height, and fitting or seg height re-marked with the frame properly adjusted.
Compare the old pair to the new one: base curve, lens design, material and frame size. (See our post on base curve.)
Give adaptation a fair chance. If everything checks out, ask the patient to wear them full-time for a week or two.
Then decide where it goes: a measurement or fabrication problem goes back to the lab with notes. If everything checks and the patient still can't see, refer them back to the doctor.
How Candor helps
When a remake comes in, we pull the original ticket so we know exactly what was made the first time, including the base curve, design and material. If you're not sure what's behind a complaint, call us before sending it back. We'll work through it with you.
Questions about a job? Call Durhl at (318) 542-2550 or email info@candoroptical.com. New to Candor? Open a wholesale account and we will follow up within 2–3 business days.





Comments